JET100 Shallow Well JET Pump, Self Priming 1 hp, 115/220 V, Cooper Winding, 141ft Head, 18.5gpm Flow, S. steel Shaft, Pressure Switch, Double Voltage

The JET line represents a family of self-priming pumps, each equipped  with a built-in ejector featuring high suction capacity. These pumps, with their multivoltage capability are designed to simplify installation and operation through the inclusion of a pressure switch. 

Key Features

Copper winding.

Robust Iron cast body pump and support .

Brass impellers.

Stainless steel shaft. 

Single phase motors 60hz and multivoltage IP 44.

Maximum aspiration up tp 26 feet.

Bulit-in thermal protector.

Suitable for continuous use,

Recommended Applications:

Aspiration in open wells and cisterns.

Home pressurization systems.

Cars wash facilities.

Light industrial services.

Small irrigations  Pumps.

Performance curve.

Technical Data.

Exploded view.

Multi Voltage 110/230v.

Installation scheme

Quick Start Guide
1. Measure the distance from the water level to the pump. This pump will lift water from a depth of 0 to 25 feet only.
2. Set the voltage switch on the pump to the same voltage as the power source.
The pump is factory wired at the factory for 230 V.
3. Connect the pump to the pipeline.
4. Make sure the foot valve is at least 10 feet below the water level and 5 feet above the bottom of the well.
5. Prime the pump by filling the pump cavity with water. IMPORTANT: All pumps must be primed before operating.
6. Turn the pump on at the switch.
CAUTION: If water does not flow, turn off the pump and check all plumbing connections for leaks. Prime again."
7. Be sure to read and understand the instructions before installing or operating this pump.

Will need
Pipe and accessories
1-1/4 in. faot valve 1 in. discharge tee
galvanized bushing
Manometer or pipe plug Pressure tank