Ideal for drawing water from boreholes up to 29 feet deep.
Suitable for pumping clean water without suspended solids.
Self-priming, with built-in ejector.
Pump + Inverter included.
Solar-powered for ecological and efficient operation.
Copper winding for durability.
Pump Specifications |
TJETS 44-900w |
Capacity [h – USGPM] |
22 |
Head [ft.] |
144 |
Impeller/ type |
Brass |
Weight (without cable) [lbs.] |
28.5 |
Outlet |
1" |
Inlet |
1" |
Suction (ft) |
30 |
|
|
Electric Motor |
|
Power [watt] |
900 |
Voltage [V] |
180-205 |
Current [A] |
9.3 |
Insulation class |
F |
Protection |
IP65 |
|
|
Materials |
|
Casing |
Cast iron |
Motor housing |
Cast iron |
Main shaft |
Stainless steel |
Performance curves
Technical data
Quick Start Guide
1. Measure the distance from the water level to the pump. This pump will lift water from a depth of 0 to 25 feet only.
2. Set the voltage switch on the pump to the same voltage as the power source.
The pump is factory wired at the factory for 230 V.
3. Connect the pump to the pipeline.
4. Make sure the foot valve is at least 10 feet below the water level and 5 feet above the bottom of the well.
5. Prime the pump by filling the pump cavity with water. IMPORTANT: All pumps must be primed before operating.
6. Turn the pump on at the switch.
CAUTION: If water does not flow, turn off the pump and check all plumbing connections for leaks. Prime again."
7. Be sure to read and understand the instructions before installing or operating this pump.
Will need
Pipe and accessories
1-1/4 in. faot valve 1 in. discharge tee
galvanized bushing
Manometer or pipe plug Pressure tank